Installation Instructions
2 INSTALL MOUNTING BRACKET
This vent hood must be secured to the horizontal support or wall studs.
•With the template taped in place, use a punch to mark mounting bracket screw locations.
•Drill 3/16″ pilot holes in 2 of the punched locations in the lower bracket.
•Remove the template.
Drill 2 (two) 3/16″ pilot holes through studs or rear wall support |
to top of
bracket
C
L
REAR WALL
MOUNTING TEMPLATE
ALIGN BOTTOM EDGE
WITH PENCIL LINE,
INDICATING BOTTOM
OF THE HOOD
▼ |
•Use wood screws to secure the mounting bracket to the wall. The screws must engage wall studs or the installed horizontal mounting support.
•Check to be sure that the bracket is level.
3 INSTALL DUCT BRACKET
The duct bracket should be installed against the back wall and flush with the ceiling. This bracket will hold the duct cover in place at the top.
Secure the bracket to the wall:
•Align the marked centerline on the bracket with the centerline on the wall.
•Mark 2 screw hole locations in the wall.
•Drill 3/16″ pilot holes in the marked locations.
•If pilot holes do not enter studs, enlarge the holes to 3/8″ and install wall fastener anchors.
•Drive screws, by hand, into the fasteners to allow anchors to expand. Remove the screws.
•Secure the bracket to the wall with wood screws and/or fasteners.
10