Installation Instructions
9 INSTALL DUCT COVERS
• Place the decorative duct
covers on top of the hood. Mounting
NOTE: The inside (upper) screws duct piece has holes on one
end. The holes are intended for use when the hood is installed for recirculating purposes. Slide the inside end into the outer piece; the vent holes should not be visible in this installation.
The inside duct piece must slip into the folded ends of the outer section.
Duct cover
support bracket
Upper duct cover
Duct cover
support bracket
Lower duct cover
Lower duct |
cover seat |
•Extend the inner duct upward to the ceiling bracket.
•Secure duct cover to ceiling bracket with 2 screws.
10 INSTALL FILTERS
IMPORTANT: Check to be sure that the main ON/OFF switch next to the motor is in the ON position.
•Remove protective film on the filters. Filter Lock
NOTE: The charcoal filter is not required for this installation.
•Tip the filter into the left or right side of the opening. Lift the filter to the opposite side and into the filter lock.
•To remove the filter, pull the filter lock downward.
11FINALIZE INSTALLATION
•Check to be sure all tape and packaging materials have been removed.
•Refer to the Owner’s Manual for operating instructions.
14