GE ZV900 Mount The Hood, Level The Hood, Connect Ductwork, Avertissement, Prudence

Installation Instructions

INSTALLATION—VENTED TO THE OUTSIDE

5 MOUNT THE HOOD

WARNING: 2 people are required to lift and position the hood onto the mounting bracket.

AVERTISSEMENT :

If faut deux personnes pour lever et mettre en place la hotte sur le support de montage.

•Lift the hood onto the mounting bracket.

•Position a spirit level at the bottom of the hood to check side to side leveling.

6 LEVEL THE HOOD

This hood has built-in levelers on the mounting hooks at each side. Use a long Phillips screwdriver from the front to access the levelers.

Levelers

•Use the top screw hole in the leveler to raise or lower the hood on that side.

•Use the bottom screw hole to pull the hood tight against the wall surface.

Screw hole

•Mark hole location at the bottom of the hood.

•Remove the hood. If the bottom screw hole does not enter a stud, enlarge the hole to 3/8″ and install wall fastener anchors.

•Place the hood back onto the mounting bracket, check level again and install the wall fastener.

7CONNECT DUCTWORK

•Install ductwork, making connections in the direction of airflow as illustrated.

•Push duct over the exhaust outlet and damper.

•Secure joints in ductwork with sheetmetal screws.

•Wrap all duct joints and the flange connections with duct tape for an airtight seal.

Airflow

Duct tape over seam

and screw Screw

CAUTION: Do not use sheet metal screws at the hood flange connection. Doing so will prevent proper damper operation. Seal connection with tape only.

PRUDENCE :

Il ne faut pas utiliser de vis autoraurdeuses à la connexion du collet de la hotte. Ceci empêcherait le bon fonctionnement du registre. N’utiliser que du ruban adhésif pour assurer l’étanchéité du raccord.

12