Installation Instructions
9 INSTALL DUCT COVERS
10 INSTALL FILTERS
•Place the decorative duct covers on top of the hood.
NOTE: The inside piece has holes on one end intended for use when the hood is installed for recirculating purposes.
Be sure the vented end is at the top; the vent holes will be visible in this installation.
Mounting
screw holes
Vent holes 
IMPORTANT: Check to be sure that the main ON/OFF switch next to the motor is in the ON position.
Charcoal filter
The inside duct piece must slip into the folded ends on the outer section.
Duct cover
support bracket
Upper duct cover
Duct cover
support bracket
Lower duct cover
Lower duct cover seat
•Extend the inner duct upward to the ceiling bracket.
•Secure duct cover to ceiling bracket with 2 screws.
•Install the black charcoal filter into the center opening. Secure the filter with thumbscrews on each side.
Metal filter
Filter Lock
•Tip the filter into the left or right side of the opening. Lift the filter to the opposite side and into the filter lock.
•To remove the filter, pull the filter lock downward.
11FINALIZE INSTALLATION
•Remove all tape and packing material.
•Refer to the Owner’s Manual for operating instructions.
19
