Installation Instructions
4PREPARE THE HOOD
•Place the hood on a padded surface.
•Position the motor housing at the back of the hood. Electrical connectors should face the front, with rear mounting hooks at the back.
•Slip the bottom flange of the motor housing into the side slots at the top rear opening.
Rear mounting
hooks
Rear view
Engage flange on motor
housing into slots
•Carefully lay the hood on its back.
•Fasten the hood to the motor housing from the bottom, using 6 screws.
Front side
Bottom view |
Rear side |
•Join two cable connectors at the front of the hood.
To Lights
To
Control
Panel
5 MOUNT THE HOOD
WARNING: 2 people are required to lift and position the hood onto the mounting bracket.
AVERTISSEMENT :
If faut deux personnes pour lever et mettre en place la hotte sur le support de montage.
•Lift the hood onto the mounting bracket.
•Position a spirit level at the bottom of the hood to check side to side leveling.
6 LEVEL THE HOOD
This hood has
Levelers
•Use the top screw hole in the leveler to raise or lower the hood on that side.
•Use the bottom screw hole to pull the hood tight against the wall surface.
Screw hole
•Mark hole location at the bottom of the hood.
•Remove the hood. If the bottom screw hole does not enter a stud, enlarge the hole to 3/8″ and install wall fastener anchors.
•Place the hood back onto the mounting bracket, check level again and install the wall fastener.
17