Hotpoint RS42J, RA513J, RA511J, RS47GJ, RS46J, RB536J, RB532GJ, RB525J Stay-upunitscamot be removed

.

Stay-upunitscamotbe removed.

Youcan lift a stay-upunit upward about 6“ and it will lock in the up position.

@Replace the drip pan and trim ring into the recess in the cooktop.

~Put the trim ring in place over the drip pan. The drip pan must be under the trim ring.

~Guide the surface unit into place so it fi~ evenly into the trim ring.

Plug-in units can be removed.

To replace a plug-in unit:

@First place the drip pan, then the trim ring into the sutiace unit cavity found on top of the coohop so the unit receptacle can be seen through the opening in the pan.

@Insert the terminals of the plug-in unit through the opening in tie drip pan and into the receptacle.

QGuide the surface unit into place so it fits evenly into the trim ring.

Note: The drip pan must be under the trim ring.

CAUTION

~Do not attempt to clean plug-insurface units in an automatic dishwasher.

@Do not immerse plug-in surface units in liquids of any tind.

@Do not bend the plug-in surface unit plug terminals.

~Do not attempt to clean, adjust or in any way repair the plug-in receptacle.

Toincreasetemperature,turn tow~~fi HI or WISE; to decrease turn towardLo or LOWER. Each notch changestemperature 10degrees.

1.Removebob, andholdso pointeris at top ofbob. Hold

“skjr-t”Ofhob firndy in one hand. With other hand, turn bob to move pointer toward Raise or Lower.

Pointer is designed not to move easily. If it is seated so it is difficult to move, pointer maybe loosened slightly.bsert a thin screwdriver, hife blade or similar instrument and lift up end of pointer slightly.

2.After adjustment is made, press pointer firdy against bob. Return bob to rar]ge, matching flat area on hob to range, matching flat area on knob and shaft. Recheck oven performance before mak~ng art additiond adjustment.

WorOtIl@rmlodels

—————.. ... -—.—...-....—--. - -—-