Solid-state drive

Description

Spare part number

 

 

256-GB SATA III solid-state drive

698645-001

 

 

128-GB SATA III solid-state drive

697235-001

 

 

128-GB SATA II solid-state drive

675508-001

 

 

Before removing the solid-state drive and cable, follow these steps:

1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect the power from the computer by unplugging the power cord from the computer.

3.Disconnect all external devices from the computer.

4.Remove the battery (see Battery on page 33).

Remove the solid-state drive:

1.Remove the Phillips PM2.0×2.0 screw (2) that secures the solid-state drive to the system board. (The solid-state drive tilts up.)

2.Remove the solid-state drive by pulling the drive away from the slot at an angle (2).

NOTE: The solid-state drive is designed with a notch to prevent incorrect installation into the solid-state drive slot.

Component replacement procedures

35