Reverse this procedure to install the top cover.

Solid-state drive connector board

Description

Spare part number

 

 

Solid-state drive connector board (includes cable)

675509-001

 

 

Before removing the solid-state drive connector board, follow these steps:

1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect the power from the computer by unplugging the power cord from the computer.

3.Disconnect all external devices from the computer.

4.Remove the battery (see Battery on page 33), and then remove the following components:

a.Solid-state drive connector board cable (see Solid-state drive on page 35)

b.Card Reader board cable (see Card Reader board cable on page 37)

c.Top cover (see Top cover on page 40)

Remove the solid-state drive connector board:

1.Turn the top cover upside down, with the front toward you.

2.Remove the Phillips PM2.0×3.6 screw (1) that secures the solid-state drive connector board to the top cover.

44

Chapter 4 Removal and replacement procedures