3.Remove the solid-state drive connector board (2).

Reverse this procedure to install the solid-state drive connector board.

Card Reader board

NOTE: The Card Reader board spare part kit does not include the Card Reader board cable. The Card Reader board cable is included in the Cable Kit, spare part number 672006-001.

Description

Spare part number

 

 

Card Reader board

696482-001

 

 

Before removing the Card Reader board, follow these steps:

1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect the power from the computer by unplugging the power cord from the computer.

3.Disconnect all external devices from the computer.

4.Remove the battery (see Battery on page 33), and then remove the following components:

a.Solid-state drive connector board cable (see Solid-state drive on page 35)

b.Card Reader board cable (see Card Reader board cable on page 37)

c.Top cover (see Top cover on page 40)

Component replacement procedures

45