Chapter 5
To reset to factory defaults
1On the control panel of the HP
2Press 8, and then press 2.
This displays the Network menu and then selects Restore Network Defaults.
3Press 1 to confirm.
Advanced network settings
The Advanced Setup options enable you to change link speed, IP settings, and memory card security.
Note Unless you are an advanced user, you should not change any of these settings.
Set link speed
You can change the speed at which data is transmitted over the network. The default is Automatic.
To set the link speed
1On the control panel of the HP
2Press 8, and then press 3.
This displays the Network menu and then selects Advanced Setup.
3Press 1 to select Change Link Speed.
4Press the number next to the link speed:
–1. Automatic
–2. 10-Full
–3. 10-Half
–4. 100-Full
–5. 100-Half
Change IP settings
The default IP setting is Automatic. However, if necessary, you can manually change the IP address, subnet mask, or the default gateway. To see the IP address and subnet mask of your HP
To change an IP setting
1On the control panel of the HP
2Press 8, and then press 3.
This displays the Network menu and then selects Advanced Setup.
3Press 2 to select IP Settings.
4Press the number next to the IP setting:
–1. IP Address
–2. Subnet Mask
–3. Default Gateway
5Enter your changes, and then press OK when done.
14