HP 2610xi, 2613, 7310, 7310xi, 2610 19

Chapter 5

server loses its network connection, you might need to reset it to factory-default and reinstall the software.

Note Do not disable TCP/IP (Transmission Control Protocol/Internet Protocol) on your computer. It is required for communication with the Embedded Web Server.

Contents

Page Page notice safety information Contents Page 1 Get started Choose a network type Use the network management tools Switch from a USB connection to a network connection Connect additional computers Get HP support Choose a recommended Ethernet network Ethernet connection to a wired network with DSL or cable Internet access Ethernet connection to a wired network with modem Internet access Ethernet connection to a wired network without Internet Ethernet connection to a wireless network Page Connect with an Ethernet cable What you need Connect your HP all-in-one 4 Install the software For Windows For Macintosh 5 Manage your network Use the HP all-in-onecontrol panel View network settings Restore network defaults Advanced network settings Use the Embedded Web Server Access the Embedded Web Server Page 6 Network troubleshooting Wired network setup troubleshooting Wired network icon To establish an active network connection I received a System Requirements Error: No TCP/IP The Printer Not Found screen appears during installation I am using a cable modem without a router and I do not have IP addresses To obtain an IP address for the PC with the cable modem To assign IP addresses to the remaining computers and the HP all-in-one Page a Configuration page definitions AutoIP: DHCP: Manual: Not Specified: Set: Wireless network settings Connected Disconnected: Disabled Not applicable <number Not Applicable Open System Shared Key WPA-PSK Miscellaneous Page Glossary Page Index

HP ProCurve manual 19

Models: 2610xi 2613 7310 7310xi 2610