HP 445946-001 manual Apply and verify the configuration, 111

Basic IP routing

4.The VLANs shown in the table above are configured as follows:

>> # /cfg/l2/vlan 1(Select VLAN 1)
>> VLAN 1# add port 20	(Add port for 1st floor to VLAN 1)
>> VLAN 1# add port 21	(Add port for 2nd floor to VLAN 1)
>> VLAN 1# ena	(Enable VLAN 1)
>> VLAN 1# ../VLAN 2	(Select VLAN 2)
>> VLAN 2# add port 18	(Add port for default router 1)
>> VLAN 2# add port 19	(Add port for default router 2)
>> VLAN 2# ena	(Enable VLAN 2)
>> VLAN 2# ../VLAN 3	(Add port for default router 3)
>> VLAN 3# add port 1	(Select VLAN 3)
>> VLAN 3# add port 2	(Select port for common server 1)
>> VLAN 3# ena	(Enable VLAN 3)

5.Each time you add a port to a VLAN, you may get the following prompt:

Port 4 is an untagged port and its current PVID is 1. Confirm changing PVID from 1 to 2 [y/n]?

6.Enter y to set the default Port VLAN ID (PVID) for the port.

7.Add each IP interface to the appropriate VLAN.

8.Now that the ports are separated into three VLANs, the IP interface for each subnet must be placed in the appropriate VLAN. The settings are made as follows:

>>VLAN 3# /cfg/l3/if 1

>>IP Interface 1# vlan 2

>>IP Interface 1# ../if 2

>>IP Interface 2# vlan 1

>>IP Interface 2# ../if 3

>>IP Interface 3# vlan 1

>>IP Interface 3# ../if 4

>>IP Interface 4# vlan 3

(Select	IP interface 1 for def. routers)
(Set to	VLAN 2)
(Select	IP interface 2 for first floor)
(Set to	VLAN 1)
(Select	IP interface 3 for second floor)
(Set to	VLAN 1)
(Select	IP interface 4 for servers)
(Set to	VLAN 3)

9.Apply and verify the configuration.

>>IP Interface 4# apply

>>IP Interface 4# /info/l2/vlan

>>Information# port

(Make your changes		active)
(View	current VLAN	information)
(View	current port	information)

10.Examine the resulting information. If any settings are incorrect, make the appropriate changes.

11.Save your new configuration changes.

>> Information# save (Save for restore after reboot)

111