Chapter 7

Check the device IP address

To check the IP address of the product, obtain the IP address by printing a network configuration page. Press the Setup button, select Network Setup, and then select Print Network Settings.

Ping the device using the IP address from the command prompt.

For example, if the IP address is 123.123.123.123, type the following at the MS-DOS prompt:

C:\Ping 123.123.123.123

Or, in Mac OS X, open Terminal (available in the Applications > Utilities folder) and type the following: ping 123.123.123

If a reply appears, the IP address is correct. If a time-out response appears, the IP address is incorrect.

The EWS is only available in English

If your product only supports wireless network connections and not Ethernet network connections, the EWS is only available in English.

Troubleshoot installation issues

If the following topics do not help, see Solve a problem for information about HP support.

Hardware installation suggestions

Software installation suggestions

Hardware installation suggestions

Check the device

Make sure that all packing tape and material have been removed from outside and inside the device.

Make sure that the device is loaded with paper.

Make sure that no lights are on or blinking except the Ready light, which should be on. If the Attention light is blinking, check for messages on the device control panel.

Check the hardware connections

Make sure that any cords and cables that you are using (such as USB cable or Ethernet cable) are in good working order.

Make sure that the power cord is connected securely to both the device and to a working power outlet.

Make sure that the phone cord is connected to the 1-LINE port.

122 Solve a problem