![](/images/backgrounds/292032/hp-psc-500-users-manual-54531813x1.png)
NOTE | Both print cartridges must be correctly installed (with the green tab and blue tape | |
| removed) for your HP PSC 500 to work. Make sure that the following things are done | |
| before continuing: | |
| • | Cartridges are pushed firmly into their slots. |
| • | Cartridge labels are facing toward you. |
| • | Both |
| • | |
| • | IN tray is pushed in completely. |
| • | Paper length adjuster is pushed firmly against the paper stack. |
| • | OUT tray is fully down. |
|
|
|
Step 4 — Connect the Printer Cable and Power Cords
NOTE | Use the printer cable that was shipped with your unit. It is a special |
| parallel, IEEE |
| for the proper functioning of your HP PSC 500. If you choose to buy a longer cable, |
| make sure it is an IEEE |
|
|
Connecting the Printer Cable
1Locate your printer cable.
2Connect the printer cable to the HP PSC 500. Pinch the clasps at the back of the cable as shown in the diagram. The cable connector is located on the back of the unit, in the middle. Make sure the cable snaps into place.
HP PSC 500 Setup Guide