simultaneously. For example, you cannot use your HP All-in-One for faxing if you are using your computer modem to send an e-mail or access the Internet.

There are two different ways to set up your HP All-in-One with your computer based on the number of phone ports on your computer. Before you begin, check your computer to see if it has one or two phone ports.

If your computer has only one phone port, you will need to purchase a parallel splitter (also called a coupler), as shown below. (A parallel splitter has one RJ-11 port on the front and two RJ-11 ports on the back. Do not use a 2-line phone splitter, a serial splitter, or a parallel splitter which has two RJ-11 ports on the front and a plug on the back.) For additional details, see the 5600 series Troubleshooting section in the onscreen HP Image Zone Help.

Example of a parallel splitter

If your computer has two phone ports, set up your HP All-in-One as described below.

setup Finish

Back view of the HP All-in-One

1 Telephone wall jack

2 "IN" phone port on your computer

3 "OUT" phone port on your computer

4 Telephone

5 Computer with modem

6 Phone cord supplied in the box with your HP All-in-One connected to the "1-LINE" port

To set up your HP All-in-One to a computer with two phone ports

1.Remove the white plug from the port labeled "2-EXT" on the back of your HP All- in-One.

User Guide

37