HP 640n Print Server manual Link Speed, Print Protocols

Table A-1HP Jetdirect EIO Menu on Graphical Control Panel (continued)

Menu item	Sub-menu item	Sub-menu item	Values and Description
Link Speed			The link speed and communication mode of the print
			server must match the network. The available
			settings depend on the device and installed print
			server. Select one of the following link configuration
			settings:
			CAUTION: If you change the link setting, network
			communications with the print server and network
			device might be lost.
			Auto (default): The print server uses auto-negotiation
			to configure itself with the highest link speed and
			communication mode allowed. If auto-negotiation
			fails, either 100TX HALF or 10TX HALF is set
			depending on the detected link speed of the hub/
			switch port. (A 1000T half-duplex selection is not
			supported.)
			10T Half: 10 Mbps, half-duplex operation.
			10T Full: 10 Mbps, Full-duplex operation.
			100TX Half: 100 Mbps, half-duplex operation.
			100TX Full: 100 Mbps, full-duplex operation.
			100TX Auto: Limits auto-negotiation to a maximum
			link speed of 100 Mbps.
			1000TX Full: 1000 Mbps, full-duplex operation.
Print Protocols			Use this item to print a page that lists the
			configuration of the following protocols: IPX/SPX,
			Novell NetWare, AppleTalk, DLC/LLC.

ENWW HP Jetdirect Menus for Graphical Control Panels 27