HP 640n Print Server manual Security, Firewall

Table A-2HP Jetdirect EIO Menu on Classic Control Panel (continued)

Menu Item	Description
SECURITY	Specify whether the current security settings on the print server will be saved or reset to
	factory defaults.
	KEEP (default): The current security settings are maintained.
	RESET: Security settings are reset to factory defaults.
IPSEC	NOTE: IPSEC will appear on the menu for both IPsec or Firewall status.
or	Specify the state of IPsec/Firewall on the print server.
Firewall	KEEP (default): IPsec/Firewall operation will be maintained as currently configured on the print
	server.
	DISABLE: IPsec/Firewall will be disabled on the print server.
PRINT	Print a configuration page for the selected item.
	PROTOCOLS: Use this item to print a page containing the configuration of the following
	protocols: IPX/SPX, Novell NetWare, AppleTalk, DLC/LLC.
	SECURITY: Use this item to print a page that contains the current security settings on the
	HP Jetdirect print server.
CFG LINK	Selects whether you want to manually configure the HP Jetdirect print server’s network link.
	NO (default): Bypass the link configuration menu items.
	YES: Access the link configuration menu items.
	The link speed and communication mode of the print server must match the network. The
	available settings depend on the print server model. One of the following link configuration
	settings can be selected:
	CAUTION: If you change the link setting, network communications with the print server and
	network device may be lost.
	AUTO (default): The print server uses auto-negotiation to configure itself with the highest link
	speed and communication mode allowed. If auto-negotiation fails, either 100TX HALF or 10TX
	HALF is set depending on the detected link speed of the hub/switch port. (A 1000T half-duplex
	selection is not supported.)
	10T HALF: 10 Mbps, half-duplex operation.
	10T FULL: 10 Mbps, Full-duplex operation.
	100TX HALF: 100 Mbps, half-duplex operation.
	100TX FULL: 100 Mbps, full-duplex operation.
	100TX AUTO: Limits auto-negotiation to a maximum link speed of 100 Mbps.
	1000 FULL: 1000 Mbps, full-duplex operation.

30 Appendix A HP Jetdirect EIO Control Panel Menus ENWW