Manuals / HP / Computer Equipment / Desktops

HP h8-1420z manual Remove the bracket from the back of the computer, Upgrading and Servicing Guide

Models: 700-406 700-410 h8-1418 700-074 h8-1420t h8-1540t 700-339 700-060 700-327c h8-1410 700-300z

1 25

Download 25 pages 47.7 Kb

Page 22

Image 22

11.Remove the bracket from the back of the computer.

12.To make it easier to access the add-in cards, disconnect the auxiliary power cable from the motherboard.

13.If the add-in card is in the large slot, press the latch to release the card.

Carefully lift the add-in card out by the edges.

14.If the add-in card is in one of the smaller slots, gently lift the card out to remove it. If there are connectors attached to the card, remove them.

15.If there are additional add-in cards to be removed, repeat step 14 for each card.

Upgrading and Servicing Guide

Features may vary by model.

Page 22

Image 22

HP h8-1420z, 700-047c Remove the bracket from the back of the computer, Carefully lift the add-in card out by the edges

Contents

Page The information contained herein is subject to change without notice Copyright 2011 Hewlett-Packard Development Company, L.PPart Number Version Removing and Replacing a Hard Disk Drive on page Features may vary by modelHP Elite 7300 MT HP Pavilion HPE h8-1000 Series PC Removing and Replacing a CD/DVD Drive on pageBefore you begin Removing and Replacing a Hard Disk DriveRemoving the hard disk drive Tools Needed6. Lift the three tabs on the front bezel to release it 7. Open the front bezel, and then remove it from the computerThe inside of the computer is exposed 8. Lay the computer on a flat surfaceFeatures may vary by model Upgrading and Servicing GuideInstalling a new hard disk drive Features may vary by model 3. Reattach the cables to the bottom end of the hard disk driveUpgrading and Servicing Guide Features may vary by model 8. Insert the two screws, securing the retaining bar in place9. Place the computer in an upright position Removing and Replacing a Hard Disk DriveFeatures may vary by model 14. Press the power button to turn on the computerUpgrading and Servicing Guide 10 - 15 minutes Removing and Replacing a CD/DVD DriveRemoving the CD/DVD drive Before you begin6. Lift the three tabs on the front bezel to release it Features may vary by modelThe inside of the computer is exposed 7. Open the front bezel, and then remove it from the computerInstalling a new CD/DVD drive Features may vary by model 3. Slide the CD/DVD drive all the way into the slot5. Connect the cables to the back of the CD/DVD drive Upgrading and Servicing GuideFeatures may vary by model 10. Press the power button to turn on the computerRemoving and Replacing a CD/DVD Drive Memory Compatibility Upgrading or Replacing MemoryRemoving the memory Before you beginLocate the memory inside the computer Installing a new memory card Troubleshooting Before you begin Upgrading or Replacing an Add-in CardRemoving the add-in card Tools Needed10. Remove the screw that secures the bracket to the computer 6. Lay the computer on a flat surface7. Remove the two screws holding the retaining bar in place Upgrading or Replacing an Add-in CardFeatures may vary by model 11. Remove the bracket from the back of the computerCarefully lift the add-in card out by the edges Upgrading and Servicing GuideInstalling a new add-in card 8. Place the computer in an upright position 7. Insert the two screws, securing the retaining bar in place5. Reattach the screw holding the bracket in place Features may vary by modelFeatures may vary by model 12. Press the power button to turn on the computerUpgrading or Replacing an Add-in Card