Manuals / HP / Computer Equipment / Desktops

HP h8-1437c, 700-047c, 700-000t, 700-030, 700-019, 700-010xt, h8-1569 Installing a new add-in card

Models: 700-406 700-410 h8-1418 700-074 h8-1420t h8-1540t 700-339 700-060 700-327c h8-1410 700-300z

1 25

Page 23

Installing a new add-in card

NOTE: The replacement part may look different than the original part because of manufacturer or model differences; however, the replacement part meets or exceeds the specifications of the original part.

1.Locate where the card will be seated inside the computer.

2.Insert the add-in card into the slot on the motherboard, making sure it is firmly seated in place.

3.If the auxiliary power cable was removed, reconnect it to the motherboard.

Features may vary by model.

Upgrading or Replacing an Add-in Card

Page 23

Image 23

HP h8-1437c, 700-047c, 700-000t, 700-030, 700-019, 700-010xt, h8-1569, h8-1540t, h8-1549, h8-1559 Installing a new add-in card

Contents

Page Part Number Version Copyright 2011 Hewlett-Packard Development Company, L.PThe information contained herein is subject to change without notice Removing and Replacing a CD/DVD Drive on page Features may vary by modelHP Elite 7300 MT HP Pavilion HPE h8-1000 Series PC Removing and Replacing a Hard Disk Drive on pageTools Needed Removing and Replacing a Hard Disk DriveRemoving the hard disk drive Before you begin8. Lay the computer on a flat surface 7. Open the front bezel, and then remove it from the computerThe inside of the computer is exposed 6. Lift the three tabs on the front bezel to release itUpgrading and Servicing Guide Features may vary by modelInstalling a new hard disk drive Upgrading and Servicing Guide 3. Reattach the cables to the bottom end of the hard disk driveFeatures may vary by model Removing and Replacing a Hard Disk Drive 8. Insert the two screws, securing the retaining bar in place9. Place the computer in an upright position Features may vary by modelUpgrading and Servicing Guide 14. Press the power button to turn on the computerFeatures may vary by model Before you begin Removing and Replacing a CD/DVD DriveRemoving the CD/DVD drive 10 - 15 minutes7. Open the front bezel, and then remove it from the computer Features may vary by modelThe inside of the computer is exposed 6. Lift the three tabs on the front bezel to release itInstalling a new CD/DVD drive Upgrading and Servicing Guide 3. Slide the CD/DVD drive all the way into the slot5. Connect the cables to the back of the CD/DVD drive Features may vary by modelRemoving and Replacing a CD/DVD Drive 10. Press the power button to turn on the computerFeatures may vary by model Before you begin Upgrading or Replacing MemoryRemoving the memory Memory CompatibilityLocate the memory inside the computer Installing a new memory card Troubleshooting Tools Needed Upgrading or Replacing an Add-in CardRemoving the add-in card Before you beginUpgrading or Replacing an Add-in Card 6. Lay the computer on a flat surface7. Remove the two screws holding the retaining bar in place 10. Remove the screw that secures the bracket to the computerUpgrading and Servicing Guide 11. Remove the bracket from the back of the computerCarefully lift the add-in card out by the edges Features may vary by modelInstalling a new add-in card Features may vary by model 7. Insert the two screws, securing the retaining bar in place5. Reattach the screw holding the bracket in place 8. Place the computer in an upright positionUpgrading or Replacing an Add-in Card 12. Press the power button to turn on the computerFeatures may vary by model