7.Insert the retaining bar in the back of the computer (1), and then align the screw holes at the front of the computer (2).
8.Insert the two screws, securing the retaining bar in place.
10.Insert the three tabs on the bezel door into the slots on the computer, and then close the bezel door until it locks in place.
11.Install the side panel on the side of the computer, and then slide it toward the front of the computer.
9.Place the computer in an upright position.
NOTE: Make sure the panel is flush with the computer. Failure to do so might cause the panel to bend slightly outward and not close securely.
Features may vary by model. | Removing and Replacing a Hard Disk Drive | 7 |
