Command Line Interface Reference Guide | vlan |
| |
name
■vlan VLAN-ID name NAME
Usage: name ASCII-STR
Description: Set the VLAN's name.
This is a VLAN context command. It can be called directly from the VLAN context or follow the 'vlan VLAN-ID' command.
nbr-timeout
■vlan VLAN-IDip pim-sparse nbr-timeout < 60 to 8000 >
Usage: ip pim-sparse nbr-timeout <60-8000>
Description: Set the neighbour loss time interval for this interface.
Default is 180 seconds.
Range: < 60 to 8000 >
nd
■[no] vlan VLAN-IDipv6 nd
Usage: [no] ipv6 nd <parameter>
Description: IPv6 nodes on the same link use Neighbor Discovery to discover each other's presence, link-layer addresses, routers and to maintain reachability information about the paths to active neighbors.
<parameter> - Configure various Neighbors Discovery parameters.
ons-interval
oreachable-time
Next Available Options:
■ns-interval-- Configures the neighbor discovery time between neighbor solicitation requests sent for an unresolved destination, or between duplicate address detection neighbor solicitation requests(p. 737)
■reachable-time-- Configures the length of time neighbors are considered reachable after being confirmed as reachable via the neighbor unreachability detection algorithm(p. 745)
no-default
■vlan VLAN-IDip irdp preference no-default
Indicates that the router should never be used as a default by its neighbors.
ns-interval
■[no] vlan VLAN-IDipv6 nd ns-interval
Usage: [no] ipv6 nd ns-interval <milliseconds>
Description: Configures the neighbor discovery time between neighbor
© 2009 Hewlett-Packard Development Company, L.P. | 737 |