Command Line Interface Reference Guide | vlan |
| |
poison-reverse
■[no] vlan VLAN-IDip rip poison-reverse
Enable/disable poison reverse on this interface.
■[no] vlan VLAN-IDip rip IP-ADDRpoison-reverse
Enable/disable poison reverse on this interface.
■[no] vlan VLAN-IDip rip all poison-reverse
Enable/disable poison reverse on this interface.
port-name
■[no] vlan VLAN-ID ip forward-protocol udp IP-ADDR < dns ntp netbios-ns ... > Supported Values:
■dns -- Domain Name Service (53)
■ntp -- Network Time Protocol (123)
■netbios-ns-- NetBIOS Name Service (137)
■netbios-dgm-- NetBIOS Datagram Service (138)
■radius -- Remote Authentication Dial-In User Service (1812)
■radius-old-- Remote Authentication Dial-In User Service (1645)
■rip -- Routing Information Protocol (520)
■snmp -- Simple Network Management Protocol (161)
■snmp-trap-- Simple Network Management Protocol (162)
■tftp -- Trivial File Transfer Protocol (69)
■timep -- Time Protocol (37)
port-num
■[no] vlan VLAN-IDip forward-protocol udp IP-ADDRTCP/UDP-PORT
UDP port number of the server.
preempt-delay-time
■[no] vlan VLAN-IDvrrp vrid < 1 to 255 > preempt-delay-time < 1 to 600 >
Usage: [no] vrrp vrid <VRID> preempt-delay-time <1-600>
Description: Allows you to specify a time in | seconds that | the Owner router |
will wait before taking control | of the virtual IP address and |
beginning to route packets. You | can configure | the time on VRRP |
| Owner and Backup routers. |
| The "no" form of the command may be used to disable the |
| pre-emptive delay timer. |
Note: | If you have configured the Preempt Delay Timer with a non-zero |
| value, you must use the "no" form of the command to change it |
| to zero. |
Parameters: | |
o preempt-delay-time <1-600> - The number of seconds to delay.
