TROUBLESHOOTING SUGGESTIONS
A. NO PART OF THE APPLIANCE WILL HEAT
1.Verify that appropriate cooking controls are ON.
2.Check electrical supply. Make sure service breaker is ON.
3.Make sure all filters are properly installed, and that no filter warning lights are lit.
4.Possible improper service wiring: Have a licensed electrician verify that all three legs of the 3ø service are properly connected
(i.e. Leg 1 to L1, Leg 2 to L2, Leg 3 to L3), and that all three legs are of the proper voltage and phase.
5.Ansul® fire suppression system not charged.
B. GRIDDLE WILL NOT HEAT
1.Verify that temperature control is set to the desired temperature.
2.Possible internal component damage: Have unit serviced by an Authorized Wells Service Agency.
C. HOTPLATE WILL NOT HEAT
1.Verify that associated temperature control is set to the desired temperature.
2.Possible internal component damage: Have unit serviced by an Authorized Wells Service Agency.
DCONVECTION OVEN WILL NOT HEAT
See Error Codes diagram at right
1.Verify that the oven switch is ON and that the temperature control is set to the desired temperature.
2.Verify that the door is closed.
3.
4.Blown fuse(s) (item 40): Correct cause of
5.Possible internal component damage: Have unit serviced by an Authorized Wells Service Agency.
E. CONVECTION OVEN FAN WILL NOT RUN
1.Verify that the oven switch is set to ON or FAN.
2.Verify that the fan switch is set to either HIGH or LOW.
3.
4.Blown fuse(s): Correct cause of
5.Possible internal component damage: Have unit serviced by an Authorized Wells Service Agency.
CAUTION:
Electrical Shock
Hazard
Removal of any cabinet panel will result in exposed electrical circuits. Any procedure requiring the removal of any cabinet panel must be performed by a qualified technician only.
CONVECTION OVEN
CONTROLLER
ERROR CODES
F1 Relay closed or relay ohms low when not cooking
F2 Actual temperature 60ºF
(±35ºF) greater than
F3 Open temperature sensor
F4 Shorted temperature sensor
F5 Relay open or relay ohms high when cooking
F6 No 60 Hz (Cycles per second other than 60 Hz detected)
Have unit serviced by an Authorized Wells Service Agency.
NOTE: There are no user serviceable components in the appliance. In all cases of damage or component malfunction, contact your Authorized Wells Service Agency for repairs.
22