GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAMS
Contents
1.1 The control panel
D OPTION SELECTION KEY E OPTION SETTING KEY
User instructions
1. Description of the controls
PROGRAMMING
SWITCHING ON
Before starting a washing program make sure that
ξ The correct amount of detergent has been added to the dispenser
Assisted programming Wizard
Standard programming
User instructions
User instructions
STARTING THE PROGRAM
FOR CERTIFICATION BODIES
Reference standard
PROGRAM
User instructions
NUMBER
LOAD CROCKERY
CONTENTS OF DISPLAY WHEN PROGRAM IS IN PROGRESS
INTERRUPTING A PROGRAM
User instructions
User instructions
CHANGING THE PROGRAM
ANNULLING A PROGRAM
END OF PROGRAM
OPTIONS available in all programs except the soak program
DELAYED START
DELAYED START depending on model
Shown on the DISPLAY G Start delay h 0, 1, .....12/24
Shown on the DISPLAY G 3/1/Normal detergent
HALF-LOAD WASH depending on model
Shown on the DISPLAY G Half load Off/Upper/Lower
USE OF 3/1 PRODUCTS OPTION depending on model
TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT
TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT
User instructions
User instructions
Enable buzzer
CUSTOMISING YOUR APPLIANCE
H2O hardness
User instructions
WATER HARDNESS TABLE
Language
REMOVING THE DISHES
TABLE OF MALFUNCTIONS DETECTED BY THE AUTODIAGNOSIS SYSTEM
2. Troubleshooting
FAULT - DESCRIPTION Fault waterblock
Safety level on
User instructions
FAULT - DESCRIPTION
Press. switch k.o
If the fault persists, call the authorised Technical Service Centre
WARNINGS AND RECOMMENDATIONS, GUIDE FOR THE USE OF BASKETS
AND FOR CLEANING DISHWASHERS
Contents
NEVER BE REMOVED
Safety instructions
1. Safety and operating instructions
USES OTHER THAN THOSE DESCRIBED ABOVE
Safety instructions
Safety instructions
AQUASTOP MODELS
APPLIANCE
Installation instructions
2. Installation and hook-up
For free-standing models only
Installation instructions
CONNECTING TO THE WATER SUPPLY
2.1 Water supply connection
DRAIN CONNECTION
NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD
2.2 Electrical connection and precautions
IF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD
Installation instructions
Installation instructions
WHEN CLEANING AND MAINTAINING THE APPLIANCE
Fuse replacement
FOR GREAT BRITAIN ONLY
3.1 Using the water softening system
3. Operating instructions
User instructions
User instructions
3.2 Using the rinse aid and detergent dispensers
ADJUSTING THE RINSE AID DISPENSER SETTING
ADDING THE RINSE AID
User instructions
User instructions
ADDING THE DETERGENT
User instructions
3.3 General warnings and recommendations
3/1 Products
Correct loading of the dishes helps ensure optimal washing results
User instructions
Dishes and objects in copper, tin, zinc or brass these tend to stain
Upper basket on the left, there are two saucers underneath the cups
3.4 Using the baskets
EN 50242 STANDARD LOADS FOR CERTIFICATION BODIES
EN 50242 cycle test conditions
User instructions
LOADING THE LOWER BASKET
User instructions
CUTLERY BASKET
UPPER BASKET
LOADING THE UPPER BASKET
User instructions
ADJUSTING THE UPPER BASKET
Version B
User instructions
User instructions
4.1 General warnings and recommendations
4. Cleaning and maintenance
CLEANING THE WATER INTAKE FILTER
CLEANING THE SPRAY ARMS
Fill the rinse aid dispenser Shut off the water supply tap
CLEANING THE FILTER UNIT
GENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT MAINTENANCE
PROLONGED DISUSE
Reconnect the water intake hose and open the tap again
TROUBLESHOOTING MINOR PROBLEMS
If the dishes are not being cleaned properly, check that
BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE
User instructions
If the dishes fail to dry or remain dull, check that
If the dishes show signs of streaking, staining, etc., check that
If there are visible traces of rust inside the tank
Page
Page
Page
Page
Page