GUIDE FOR USING THE DISHWASHER AND THE WASHING PROGRAMS
Contents
User instructions
D OPTION SELECTION KEY E OPTION SETTING KEY
1. Description of the controls
1.1 The control panel
Before starting a washing program make sure that
SWITCHING ON
ξ The correct amount of detergent has been added to the dispenser
PROGRAMMING
Standard programming
Assisted programming Wizard
User instructions
FOR CERTIFICATION BODIES
STARTING THE PROGRAM
Reference standard
User instructions
NUMBER
User instructions
LOAD CROCKERY
PROGRAM
INTERRUPTING A PROGRAM
CONTENTS OF DISPLAY WHEN PROGRAM IS IN PROGRESS
User instructions
ANNULLING A PROGRAM
CHANGING THE PROGRAM
END OF PROGRAM
User instructions
DELAYED START depending on model
DELAYED START
Shown on the DISPLAY G Start delay h 0, 1, .....12/24
OPTIONS available in all programs except the soak program
Shown on the DISPLAY G Half load Off/Upper/Lower
HALF-LOAD WASH depending on model
USE OF 3/1 PRODUCTS OPTION depending on model
Shown on the DISPLAY G 3/1/Normal detergent
TO CUT DOWN ON DETERGENT CONSUMPTION! … AND PROTECT THE ENVIRONMENT
TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT
User instructions
CUSTOMISING YOUR APPLIANCE
Enable buzzer
H2O hardness
User instructions
Language
WATER HARDNESS TABLE
REMOVING THE DISHES
User instructions
FAULT - DESCRIPTION Fault waterblock
2. Troubleshooting
Safety level on
TABLE OF MALFUNCTIONS DETECTED BY THE AUTODIAGNOSIS SYSTEM
Press. switch k.o
FAULT - DESCRIPTION
If the fault persists, call the authorised Technical Service Centre
User instructions
WARNINGS AND RECOMMENDATIONS, GUIDE FOR THE USE OF BASKETS
AND FOR CLEANING DISHWASHERS
Contents
1. Safety and operating instructions
Safety instructions
USES OTHER THAN THOSE DESCRIBED ABOVE
NEVER BE REMOVED
Safety instructions
AQUASTOP MODELS
Safety instructions
APPLIANCE
2. Installation and hook-up
Installation instructions
For free-standing models only
2.1 Water supply connection
CONNECTING TO THE WATER SUPPLY
DRAIN CONNECTION
Installation instructions
IF THE APPLIANCE IS PROVIDED WITH A PLUGLESS SUPPLY CORD
2.2 Electrical connection and precautions
Installation instructions
NEVER DISCONNECT THE PLUG BY PULLING ON THE POWER SUPPLY LEAD
Fuse replacement
WHEN CLEANING AND MAINTAINING THE APPLIANCE
FOR GREAT BRITAIN ONLY
Installation instructions
3. Operating instructions
3.1 Using the water softening system
User instructions
User instructions
3.2 Using the rinse aid and detergent dispensers
ADDING THE RINSE AID
ADJUSTING THE RINSE AID DISPENSER SETTING
User instructions
User instructions
ADDING THE DETERGENT
3/1 Products
3.3 General warnings and recommendations
Correct loading of the dishes helps ensure optimal washing results
User instructions
User instructions
Dishes and objects in copper, tin, zinc or brass these tend to stain
EN 50242 STANDARD LOADS FOR CERTIFICATION BODIES
3.4 Using the baskets
EN 50242 cycle test conditions
Upper basket on the left, there are two saucers underneath the cups
User instructions
LOADING THE LOWER BASKET
User instructions
CUTLERY BASKET
LOADING THE UPPER BASKET
UPPER BASKET
User instructions
Version B
ADJUSTING THE UPPER BASKET
User instructions
User instructions
CLEANING THE WATER INTAKE FILTER
4. Cleaning and maintenance
CLEANING THE SPRAY ARMS
4.1 General warnings and recommendations
GENERAL WARNINGS AND RECOMMENDATIONS FOR CORRECT MAINTENANCE
CLEANING THE FILTER UNIT
PROLONGED DISUSE
Fill the rinse aid dispenser Shut off the water supply tap
If the dishes are not being cleaned properly, check that
TROUBLESHOOTING MINOR PROBLEMS
BEFORE STARTING THE DISHWASHER AFTER PROLONGED DISUSE
Reconnect the water intake hose and open the tap again
If the dishes show signs of streaking, staining, etc., check that
If the dishes fail to dry or remain dull, check that
If there are visible traces of rust inside the tank
User instructions
Page
Page
Page
Page
Page