User instructions
FAULT - DESCRIPTION
Flow meter k.o. (for the relevant models only)
The appliance is not able to "measure" the amount of water loaded accurately. The alarm is displayed at the end of the cycle, which however is completed since the problem does not interfere with operation of the dishwasher. If the problem persists, contact the
Zone washing k.o. (for the relevant models only)
Interrupt the program and switch off the dishwasher. Switch the dishwasher back on, program it again and start the washing cycle. If the problem persists, contact the after- sales service.
Press. switch k.o.
Contact the
ξ"Fault waterblock", "Safety level on", "Heating k.o.", "Temper. feeler k.o.", "Zone washing k.o." and "Press. switch k.o." trigger an immediate termination of the program in progress.
ξ"Watertap closed" and "Drain obstructed" interrupt the program in progress and then continue it as soon as the cause of the problem has been dealt with.
To “reset” an alarm is necessary:
ξOpen and close the door, or turn off and on the machine. At this point is possible to program the dishwasher again.
If the fault persists, call the authorised Technical Service Centre.
33
