Smeg ST1146SE manual If the dishes fail to dry or remain dull, check that

User instructions

If the dishes fail to dry or remain dull, check that:

•there is rinse aid inside the special container;

•the rinse aid dispenser setting is correct;

•the detergent used is of good quality and has not lost its effectiveness (for example, through incorrect storage, with the box left open).

If the dishes show signs of streaking, staining, etc., check that:

•the rinse aid dispenser setting is not too high.

If there are visible traces of rust inside the tank:

•the tank is made of steel, and therefore any rust marks are due to external elements (fragments of rust from the water pipes, pots, cutlery, etc.). Special products are commercially available to remove such marks;

•check that the amount of detergent being used is correct. Certain detergents can be more corrosive than others.

•check that the cap of the salt container is securely closed, and that the water softening setting is correct.

If after following the above troubleshooting instructions the problem persists, call the nearest After-Sales Centre.

WARNING: any operations performed on the appliance by unauthorised persons are not covered by the warranty and shall be paid for by the user.

TECHNICAL DATA
Width	597 ⎟ 599 mm
Depth measured flush with the	Free standing: 600 mm
outer edge of the control panel	Semi-integrated: 590 mm - Fully integrated: 570 mm
Height (depending on models)	Free standing: from 850 mm to 870 mm
	from 890 mm to 910 mm
	Semi-integrated and fully integrated: from 820 mm to 870 mm
	from 860 mm to 910 mm
Capacity	14 Standard place settings
Water supply pressure	min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar)
Electrical characteristics	See rating plate