Installing the A5150A Adapter

Looking at Adapter Installation

NOTE

The host bus adapter card is supported on the HP N4000 N-class system.

 

Refer to the Hewlett-Packard eproducts web site

 

(http://www.eproducts.hp.com) to disassemble the system, install the

 

adapter in an available PCI slot, and reassemble the system.

 

 

IMPORTANT

Install Using OLAR (HP-UX 11i)

The letters O, L, A and R stand for On Line Addition [and] Replacement. This refers to the ability of a PCI I/O card to be installed (replaced or added) in an HP-UX computer system designed to support this feature without the need for completely shutting down, then re-booting the system or adversely affecting other system components. The system hardware uses the per-slot power control combined with operating system support in HP-UX 11i to enable this feature.

Certain “Classes” of hardware are not intended for access by users. At this time this includes V-Class and SuperDome systems. HP recommends that these systems only be opened by a qualified HP Engineer. Failure to observe this requirement can invalidate any support agreement or warranty to which the owner might otherwise be entitled.

Important Terms and Concepts

The addition or replacement of an OLAR-compatible card may be done in either one of two ways:

1.Using the SAM utility.

2.Issuing command-line commands using rad.

For detailed information about the use of either of these two procedures, please refer to the following document:

Configuring HP-UX For Peripherals, HP Part Number B2355-90698

This document may be ordered from HP, or you may view, download and print it from the following website: www.docs.hp.com

20

Chapter 2