Installing the A5150A Adapter
Looking at Adapter Installation
| OLR of |
| initiator ID and speed settings across the replacement. The auto |
| termination setting for this HBA is |
| the board. |
| Before installation, ensure that the auto termination jumpers are set to |
| the same position as they were on the replaced HBA. |
| Besides the cautions noted above, the |
| Replaced without special considerations. See the Configuring |
| Peripherals manual for the steps that are necessary to OLR this HBA. |
| OLR of |
| one special consideration. |
| The HBA being replaced MUST have been running with auto termination |
| enabled. |
| If the above condition is met, you may OLR the HBA. See the |
| Configuring |
| to OLR this HBA. |
|
|
NOTE | Until you complete the OLR, additional SCSI error messages might be |
| written to the /var/adm/syslog.log file. Do not be concerned about |
| these messages; they do not affect the result of the OLR process. |
|
|
Install/Replace With System Powered Down
Check the manual supplied with the server to perform the following installation:
Step 1. Shut down the operating system.
Step 2. Power off the system and unplug power cords for all components in the server.
Step 3. Locate the PCI slots for your server. Remove any cabinet cover.
Chapter 2 | 25 |