Installing the A5150A Adapter
SCSI Bus Termination
Step 1. Check the PDC version, by booting the system to the BCH prompt and then doing the following:
a.At the Main Menu, type in (for Information Menu).
b.At the Information Menu, type fv (to display the firmware version). The output could look like this:
FIRMWARE INFORMATION
Firmware Version: | 39.41 |
Table
Step 2. Determine the HBA’s path by doing the following:
a.If already at the Main Menu, type in (for Information Menu); go to step b.
If not already at the Main Menu, type main (to return to the Main Menu), type in (for Information Menu), then go to step b.
b.At the Information Menu, type io (to display I/O interface information). The output could look like this:
PCI DEVICE INFORMATION
| Path | Vendor | Device | Bus | Slot |
Description | (dec) | ID | ID | # | # |
. |
|
|
|
|
|
. |
|
|
|
|
|
SCSI bus cntrl | 0/2/0/0 | 0x1000 | 0xb | 16 | 6 |
In this example, the HBA’s path is 0/2/0/0 (shown in bold, for emphasis, in the listing above).
Step 3. Change the HBA’s auto termination state by doing the following:
a. If already at the Main Menu, type ser (for Service Menu); go to stepb.
If not already at the Main Menu, type main (to return to the Main Menu), type ser (for Service Menu), then go to step b.
34 | Chapter 2 |