Installing the A5150A Adapter
SCSI Bus Termination
| The HBA is not able to distinguish |
| SCSI cables. If an |
| has auto termination enabled, termination will be provided by both the |
| cable and the HBA. This would result in improper (double) termination |
| of the SCSI bus. To prevent this, disable auto termination any time |
| |
| Scenario Seven |
| |
| any HBAs installed in a |
| termination when they are shipped from |
| Scenario Eight |
| High Availability configurations use |
| so you must disable auto termination on any HBAs used in an HA |
| environment. |
| How to Turn Off Auto Termination |
| You control the auto termination feature through commands at the BCH |
| prompt. See the steps below. |
|
|
NOTE | The following steps and examples are specific to |
| Menus, commands, and responses will be slightly different on other |
| systems. |
| To change the auto termination state of an A5150A HBA, follow these |
| |
| steps: |
Chapter 2 | 33 |