Replacing Small Parts

(User-Replaceable)

The following small parts are user-replaceable.

Part

Docking Doors

Feet

Hinge Cover, Left

Hinge Cover, Right

I/O Door

Pointing Stick Cap

RAM/BIOS Cover

VGA Connector Cover

Table 2-6. Replacing Small Parts (User-Replaceable)

Replacement Procedure

Open each door and flex the door until one side tab releases. To replace, see the picture on page 2-28.

Insert a small flat-blade screwdriver under the foot and pry it loose. To replace, firmly press the adhesive side of the foot into the recess.

With the display lid fully open, push back on the bottom edge of the hinge cover until it unsnaps, then work it loose and lift it off. To install, make sure the front and back tabs snap into the case.

With the display lid closed, push in the bottom of the hinge cover until it unsnaps, then work it loose and lift it off. To install, make sure the front and back tabs snap into the case.

With the door closed, insert a small flat-blade screwdriver behind the door from below. Flex the door until one side tab releases. It helps to press in lightly on the ends of the door. To install, keep the icons on the door toward the top.

Pull the cap off the pointing stick.

On the bottom of the unit, remove the two screws from the RAM/BIOS cover and remove the cover.

With the display closed, push up on the connector cover and down on the bottom case until the lower tabs release. To install, insert the top tabs into the strip cover, then push up on the cover and down on the bottom case until you can insert the lower tabs.

2-8

Removal and Replacement

HP OmniBook 4100/4150