Removing the Display Assembly

(HP Authorized Service Providers Only)

Required Equipment

Small Phillips screwdriver.

Removal Procedure

1.Unplug the ac adapter, if present, and remove the battery.

2.On the back of the unit, lift up on the VGA connector cover above the VGA port and unsnap it from the case.

3.Remove the screw above the VGA port.

4.Remove the four “D” screws from the bottom case.

5.Open the display about 90 degrees, then lift off and lay back the combined top-case strip cover and display assembly. Do not lose the two springs from the bottom case.

6. Remove the two screws from the LCD flex cable end and unplug the cable.

Caution:

Install new screws after removing the two 16mm screws at the corners.

Screw, M2.5×16mm (2)

Screw, M2×4mm

Strip cover

LCD flex cable

Screw, M2.5×5mm

(1)

VGA connector cover

Screw, M2.5×5mm

Note:

Screw, M2.5×19mm

(2)

Loose spring located in each hole (2).

Figure 2-6. Removing the Display

HP OmniBook 4100/4150

Removal and Replacement 2-11