1

13

14

25

Figure 2-16. Boot-Block Jumper

Removing Other Components

(HP Authorized Service Providers Only)

Required Equipment

∙Small Phillips screwdriver.

∙Pointed knife or probe (for display components).

∙5-mm hex driver (or 3/16 inch) (for bottom case components).

Removal Procedure

1.Unplug the ac adapter, if present, and remove the battery.

2.Remove the additional assemblies and follow the special steps indicated in the tables below. Components are separated into these groups:

∙Display components (below).

∙Top case components (page 2-32).

∙Bottom case components (page 2-33).

Table 2-9. Removing Display Components

Component

Cable Holder

(part of display case kit)

Display Bezel

Removal Procedures

Display (page 2-11).

Display (page 2-11)

Additional Steps (See figure on page 4-7)

1.Remove the display bezel (page 2-13).

2.Unsnap the cover of the cable holder.

3.Use a flat-blade screwdriver to pry the display case and release the cable holder.

Reassembly Notes: Install the holder so the tabbed side is toward the bottom of the display case.

Remove the display bezel (page 2-13). Caution: Use compatible parts (page 2-13).

Display Case

Display (page 2-11).

Remove the LCD module and brackets from the case,

 

 

but do not disassemble the module (page 2-13).

 

 

Reassembly Notes: Transfer the display latch and

 

 

cable holder from the old display case.

 

 

Caution: Use compatible parts (page 2-13).

HP OmniBook 4100/4150

Removal and Replacement 2-31