•The HP D2D is supplied with an HP Smart Array P400 controller (with 512 MB and BBWC) pre-installed in one of the full-height PCI-e slots. For more information about this card, search on http://www.hp.com/support/manuals. Part numbers are as follows:

◦P400 card: 441823–001

◦512 MB memory: 405835–001

◦BBWC: 398648–001

◦BBWC cable assembly: 409125–001

•The FC model has an HP Dual Channel 4Gb PCIe Fibre Channel Host Bus Adapter, part number AE312A

Figure 6 Rear view of the HP D2D4004/4009

1.Power supply cable sockets (two)

2.LAN port 1 (always used for data connection)

3.LAN port 2

4.Management LAN port (Do not connect to this port)

5.PCIe slots (two full and one low profile)

6.VGA port for system console monitor

7.PS/2 ports for system console keyboard and mouse

NOTE: One full PCIe slot has a SmartArray RAID controller card pre-installed. The other full PCIe slot is used for the FC card. You must install the Tape Attach card (SAS or SCSI) in the low profile slot.

Using the ProLiant Guide with HP D2D2502 G1 models

When using the HP ProLiant DL165 G5 guide, be aware of the following HP D2D-specific information:

•The AMD Opteron 2376 2.3GHz (75W), part number 495643-003, is the only processor that is supported.

•The HP D2D has four fixed hard disks.

•There is no optical media storage.

12 Introduction