Upgrading and replacing hardware
Configuring an IDE device after installation
After installing any device, you can check via the Summary Screen that your PC has correctly identified the new configuration. To view the Summary screen, press F8 during startup, then select Summary from the list of options.
If the configuration is not correct, run the Setup program to configure the device. To enter the Setup program, press F8 during startup, then select Setup from the list of options.
IDE drives are automatically detected by the Setup program. However, a newly installed device may required that you install an appropriate device driver. Refer to your operating system documentation for details. You can obtain the latest drivers from the support web site.
The IDE cables in your PC are cable select. You must, therefore, set the jumpers on any IDE devices you install to cable select. See the documentation for the device for more information.
