8.If you are adding a second SODIMM, remove the SODIMM from the top DIMM1 socket to access the bottom DIMM3 socket. Press outward on the two latches on each side of the SODIMM (1) then pull the SODIMM out of the socket (2).
Figure 2-7 Removing a SODIMM
9.Slide the new SODIMM into the socket at approximately a 30° angle (1) then press the SODIMM down (2) so that the latches lock it in place.
Figure 2-8 Installing a SODIMM
NOTE: A memory module can be installed in only one way. Match the notch on the module with the tab on the memory socket.
A SODIMM must occupy the DIMM1 (top) socket.
10.Replace the SODIMM in the DIMM1 socket if it was removed.
11.Replace the access panel.
12.If the computer was on a stand, replace the stand.
ENWW | Installing Additional Memory 17 |
