Display subcomponents (bezel, webcam, panel)
This section describes removing display subcomponents that do not require that you remove the entire display assembly from the computer. You can remove the display bezel, webcam/microphone module, and display panel while the display assembly is still attached to the computer.
To remove the remaining display subcomponents, including the hinge covers, hinges, cable, antennas, and enclosure, you must remove the entire display assembly from the computer. See Display assembly
on page 71 for more information about removing the display assembly in its entirety.
Description | Spare part number |
|
|
Display bezel (includes Mylar screw covers) | |
|
|
Webcam/microphone module, HD | |
|
|
|
|
Before removing the display bezel, webcam/microphone module, and display panel while the display assembly is still attached to the computer, follow these steps:
1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect all external devices connected to the computer.
3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.
4.Remove the battery (see Battery on page 36).
To remove the display bezel, webcam/microphone module, and display panel while the display assembly is still attached to the computer:
1.Position the computer
2.Remove the two Mylar screw covers (1) and the two Phillips PM2.5×4.0 screws (2) that secure the display bezel to the display assembly. The Mylar screw covers are included with the display bezel spare part kit.
ENWW | Component replacement procedures 37 |
