Wireless Connection using a WPS enabled router

To connect the HP All-in-One to a wireless network using WiFi Protected Setup (WPS), you will need the following:

￿A wireless 802.11 network that includes a WPS-enabled wireless router or access point.

￿A desktop computer or laptop with either wireless networking support, or a network interface card (NIC). The computer must be connected to the wireless network that you intend to install the HP All-in-One on.

Wireless Connection using a WPS enabled router

Do one of the following:

Use Push Button (PBC) method if your router has a WPS button a. Set up wireless connection.

￿Press and hold the Wireless button for two seconds.

￿Press the corresponding button on the WPS-enabled router or other networking device.

￿The Wireless icon and signal strength bar appear solid on successful configuration of the wireless network.

b. Install Software.

NOTE: The product begins a timer for approximately two minutes in which the corresponding button on the networking device needs to be pressed.

Use PIN method if your WPS enabled router does not have a WPS button

a. Load paper.

￿Insert stack of paper into paper tray with short edge forward and print side down.

￿Slide stack of paper forward until it stops.

￿Slide paper-width guide to the right until it stops at edge of paper.

Finish setting up the HP All-in-One

Finish setting up the HP All-in-One

5