8.Slide the TouchPad button board bracket (3) up and away from the top cover until the tabs (4) on the front edge of the bracket disengage from the slots (5) on the top cover.

Reverse this procedure to install the TouchPad button board.

Solid-state drive

Description

Spare part number

 

 

180-GB solid-state drive for use on all computer models

699330-001

 

 

160-GB solid-state drive for use on all computer models

681997-001

 

 

32-GB mSATA solid-state drive for use only on computer models equipped with an Intel processor

682099-001

 

 

Before removing the solid-state drive, follow these steps:

1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect the power from the computer by unplugging the power cord from the computer.

3.Disconnect all external devices from the computer.

4.Remove the battery (see Battery on page 47), and then remove the following components:

a.Hard drive (see Hard drive on page 48)

b.Optical drive (see Optical drive on page 53)

72

Chapter 4 Removal and replacement procedures