Installing the SCSI Miniport Driver

Device Driver Installation

This section describes the instructions for installing the Windows SCSI Miniport driver.

System Requirements

Ensure that your system meets these minimum requirements:

■Installed HBA

■StorageWorks Fibre Channel Storage subsystem (interconnect device and storage device)

Installing or Upgrading a New Driver

The AB232A HBA is a plug-and-play device that is detected by Windows operating systems. Perform the following steps to add or update the Windows driver to a previously installed Windows system:

1.Install the HBA as described in Chapter 2 on page 17.

2.Restart or turn on the computer.

3.Browse to the the driver kit on the Smart Setup CD-ROM (or one you downloaded from the website if it is more recent).

4.Double-click cp00xxxx.exe.

Note: Refer to the following website for the information about this Smart Component’s final version number: http://h18000.www1.hp.com/storage/saninfrastructure.html.

5.Follow the installation wizard instructions.

6.When the installation completes, you must reboot.

7.Repeat step 1 through step 6 for any additional HBAs. Make sure to reboot after installing the driver for the last HBA.