HP FCA2404 AB232A AB232A manual Parameter Description

Diagnostic and Configuration Utilities

Table 8: Drive Parameters (Continued)

Parameter	Description
QueueDepth = n	Values from 1–64 (decimal). Default = 64. Requests per
	LUN/Target (see Queue Target parameter).
QueueTarget = n	Values 0 or 1 (decimal). Default = 0. 0 = QueueDepth
	applies on a per LUN basis: 1 = QueueDepth applies on
	a Target basis.
RATOV = n	Values are in seconds from 2 to 120. Default = 2. This
	value is the ELS request time-out.
ReadCheck = n	Values 0 or 1. Default = 1. 0 = do not enable byte
	counting for read operations. 1 = enable byte counting. If
	bytes counted are less than requested transfer count,
	issue underrun.
ResetFF = n	Values 0 or 1. Default = 1. 0 = ResetBus translates to LIP
	(F7). 1 = ResetBus translates to LIP (FF). Used for
	WolfPack to force reservations to be freed when
	ResetBus issued. Only meaningful for FC_AL topology
	and Seagate native FC hard drives.
ResetTPRLO = n	Values 0 or 1. Default = 1. 0 = ResetBus translates to LIP
	(). 1 = ResetBus translates to ThirdPartyProcessLogout +
	LIP (). Used for WolfPack to force reservations to be
	freed when ResetBus is issued.
RetryInterval = n	Values are in seconds from 2-255. Default = 45. Used for
	time-out interval if RetryloTimeOut = 1. Must be shorter
	than Class driver TimeOutInterval.
RetryloTimeOut = n	Values 0 or 1. Default = 1. 1 = allows HBA to time-out I/O
	prior to port driver’s time-out that causes a LIP/Link
	Reset.
RTTOV = n	Values are in milliseconds from 100 to 511. Default =
	256. Represents time-out between phases of Off-line to
	On-line protocol.
ScanDown = n	Values 0 or 1. Default = 0. 0 = Lowest AL_PA = Lowest
	physical disk (ascending AL_PA order). 1 = Highest
	AL_PA = Lowest Physical Disk (ascending SEL_ID
	order).

42 AB232A PCI-X Host Bus Adapter Installation Guide