HP FN038UAABA, FN037UAABA manual Display assembly

Display assembly

NOTE: All display assembly spare part kits include 3 WLAN antenna transceivers and cables.

Description	Spare part number
17.0-inch, WUXGA+ WVA AntiGlare display assembly without camera module	494016-001
17.0-inch, WUXGA+ WVA AntiGlare display assembly with camera module	494017-001
17.0-inch, WSXGA+ WVA AntiGlare display assembly without camera module	494012-001
17.0-inch, WSXGA+ WVA AntiGlare display assembly with camera module	494013-001
17.0-inch, WUXGA DreamColor display assembly without camera module	494014-001
17.0-inch, WUXGA DreamColor display assembly with camera module	494015-001
17.0-inch, WXGA+ AntiGlare display assembly without camera module	494018-001
17.0-inch, WXGA+ AntiGlare display assembly with camera module	494019-001

Before removing the display assembly, follow these steps:

1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the computer.

3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.

4.Remove the battery (see Battery on page 41).

5.Remove the keyboard (see Keyboard on page 55).

6.Remove the switch cover (see Switch cover on page 59).

Remove the display assembly:

1.Turn the computer upside down, with the rear panel toward you.

2.Remove the four Torx T8M2.5×9.0 screws (1) from the rear panel that secure the display assembly to the computer.

3.Remove the Torx T8M2.5×9.0 screw (2) from the left rear corner of the computer.

70 Chapter 4 Removal and replacement procedures