Fingerprint reader board
Description | Spare part number |
|
|
Fingerprint reader board (includes cable) | |
|
|
Before removing the fingerprint reader board, follow these steps:
1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.
2.Disconnect the power from the computer by unplugging the power cord from the computer.
3.Disconnect all external devices from the computer.
4.Remove the battery (see Battery on page 40), and then remove the following components:
a.Hard drive cover (see Hard drive cover on page 45)
b.Hard drive (see Hard drive/SSD drive on page 46)
c.Service cover (see Service cover on page 51)
d.Keyboard (see Keyboard on page 58)
e.Base enclosure (see Base enclosure on page 61)
f.Fan (see Fan on page 66)
g.System board (see System board on page 67)
Remove the fingerprint reader board:
1.Position the system board upside down.
2.Disconnect the fingerprint reader board cable from the system board connector, and then remove the assembly.
3.Remove the fingerprint reader board and cable. Reverse this procedure to install the fingerprint reader board.
Component replacement procedures 75