HP Gigabit Ethernet and 100Base-T Cards manual Network Card Configuration Worksheet

HP-UX Installation

Network Card Configuration Worksheet

Network Card Configuration Worksheet

Fill out one worksheet for each network card you are installing.
Table 1-1	Ethernet Card Configuration Worksheet
Data Type	Required/	Default	How to Configure	Example	Your
	Optional		(see Note 1)		System
Internet	Required	0.0.0.0	SAM or ifconfig or	196.6.20.2
Address			edit
			/etc/rc.config.d/
			netconf
Subnet mask	Required if	Subnet mask	SAM or ifconfig or	255.255.248.0
	using	not used	edit
	subnetting		/etc/rc.config.d/
			netconf
Station	Built-in but	As shown on	SAM or edit	0x0060b0c4012f
address	can be	card	/etc/rc.config.d/
	optionally		hpietherconf or
	changed		temporarily:
			lanadmin -A
Host name	Required if	None	SAM or edit	host1
alias for this	the system		/etc/hosts
network	is connected
interface	to more than
(card)	1 network
Link	Required	Autonegotiating	SAM or temporarily:	lanadmin -X
configuration			lanadmin -X	auto_on ppa#
				(if already
				turned off)
Link speed/	Required	Autonegotiating	Hub or switch (see	lanadmin -X
duplex mode			Note 2) SAM or	100fd ppa#
			temporarily:
			lanadmin -X
MTU	Optional	1500 bytes	SAM or edit	lanadmin -M
(Maximum			/etc/rc.config.d/	9000 ppa# (see
Transmission			hpietherconf or	Note 3 below)
Unit): Jumbo			temporarily:
Frames			lanadmin -M
Receive flow	Optional	On	SAM or edit	lanadmin -X
control			/etc/rc.config.d/	fctrl off
			hpietherconf or
			temporarily:
			lanadmin -X

Chapter 1 9