Deployment 43
To physically install MAPs:
1Instruct the cabling installer to run the Cat. 5 Ethernet cable from the closest wiring closet to intended location of the MAP.
2Unpack the MAP, and select the appropriate mounting kit for your installation location.
3Install the MAP at the indicated location on the floor.
4Connect the Cat 5. Ethernet cable(s) to the MAP.
5At the wiring closet, connect the MAP to the infrastructure equipment:
a If you are directly connecting the MAP to a WX switch, plug the other cable end(s) to the indicated port(s).
b If you are indirectly connecting the WX to the switch, plug the other cable end(s) to an available network port on the wiring closet switch. If the switch does not supply PoE, then ensure that a
Deployment | Deployment is when WX configuration information in the 3WXM |
| network plan is sent to your WX switch. |
| Configuration changes are collected in 3WXM when you save them, but |
| are not applied to WX switches until you send the configuration to the |
| WX switch and deploy the configuration to your network. Any changes |
| you make to your network in 3WXM are saved, but not applied to your |
| network until they are deployed. This method makes it easy to apply |
| configurations simultaneously to multiple WX switches, or you can deploy |
| changes to a single WX switch. |
