Plan RF Coverage 139

3You can checkbox Optimize AP Count.

Use this option if you moved or added MAP access points on the floor plan after computing and placing them, or if you changed an MAP to model MP-262. This option is disabled by default.

4Select Compute Power for the areas for which you want to compute power.

5Click Next. The Compute Power For Progress page appears. Click Finish to see the results.

Display Coverage Looking at the RF coverage allows you to see if the entire area is adequately covered by the MAP access points. You can move the MAPs and see how the coverage changes.

To display the RF coverage for an area:

1Beside Show RF Coverage Using, select how you want to display the coverage:

„Baseline Association Rate—Coverage is shown based on the MAP radio baseline association rate. The baseline association rate is the typical data rate the radio is expected to support for client associations. (The baseline association rate is specified during planning, on a coverage area basis.)

Page 139
Image 139
3Com 3CRWX120695A, 3CRWX440095A, CRWXR10095A manual Plan RF Coverage