CS SL MA
Example drive with Cable Select jumper installed (your drive may vary)
Installing a second hard drive
If your PC model does not have a
1 Remove the drive cage. (See page 52.)
2 Make sure the jumper on the new hard drive is in the CS (Cable Select) position. Slide the new drive into the empty slot in the drive cage until the screw holes align.
3 Install the two screws.
4 Replace the drive cage. (See page 53.)
5 Attach the power cable to the back of the drive.
6 Attach the connector marked Master on the IDE ribbon cable to the back of the preinstalled hard drive. After the preinstalled hard drive connection is attached, twist the remaining part of the cable, marked Slave on that same IDE ribbon cable, and connect it to the second hard drive.
7 If necessary, connect the IDE cable connector marked Motherboard or CPU board to the motherboard.
A jumper is a small plastic connector or wire which electrically connects two pins in order to define
aconfiguration setting.
Upgrading
55