HP NetMail/3000 manual Special Terminal Types, Setjcw NETMAILHPTERM=1

NetMail/3000 Menu Interface

Users Guide

Special Terminal Types

If you need to run NetMail/3000 and you are connecting to the HP3000 over an X.25 net- work or use a terminal type other than the default (termtype 10), you will notice that NetMail/ 3000 treats your terminal as a non-HP terminal and will not use HP escape sequences necessary to handle some of the special display enhancements NetMail/3000 usually uses. This occurs because NetMail/3000 by default will only check for HP terminals (by issuing a special proprietary HP terminal escape sequence) if the user’s terminal is configured as the default terminal type (term- type 10). If you are using some other terminal type but are still using an HP terminal and want to take full advantage of the display enhancements NetMail/3000 uses, issue the following MPE command before running NetMail/3000:

:SETJCW NETMAILHPTERM=1

This will override the terminal type checking and force NetMail/3000 to go ahead and issue the necessary escape sequences to recognize HP terminals (or emulators).

In addition, you can utilize NetMail/3000’s MENU interface on many non-HP terminals. To do so, you will need to set a JCW (job control word) identifying the terminal type you are using before you run NetMail/3000. The following lists the supported terminal types:

For the following terminal types:	Enter the following command:
DEC VT52	:SETJCW term,5
DEC VT100	:SETJCW term,6
DEC VT220	:SETJCW term,10
DEC VT52k	:SETJCW term,11
DEC VT100k	:SETJCW term,12
DEC VT220k	:SETJCW term,13
DEC VT320	:SETJCW term,14
WYSE-50	:SETJCW term,7
WYSE-30	:SETJCW term,15
IBM 3101	:SETJCW term,20
ADDS Viewpoint	:SETJCW term,17
Televideo 910	:SETJCW term,18

2-97