Installing the Fibre Loop Switch

Figure 6: Mounting in HP Rack System/E and HP Rack System/U Racks

Right Front Rack Column

Left Front

Rack Column

"L" Spacer

"R" Spacer

Sleeves

Right Rear Rack Column

Switch

Left Rear Rack Column

Rails

Tools Required

To install the switch in an HP rack, you need a T25 Torx driver and a #1 Phillips- head screwdriver.

HP Rack Mounting Installation Steps

Installing the fibre loop switch into an HP rack requires the following general steps:

Step 1: Preparation

Step 2: Mark the Rack Column Holes

Step 3: Place the Barrel Nuts on the Rack Columns

Also install the “L” and “R” spacers on the front columns of HP Rack System/E and HP Rack System/U racks only.

15

Page 23
Image 23
HP P4459A manual Tools Required